|
Page 3 of 13
Affixing the Engine
(Continued)
If you have purchased a bike in which the frame fits the motor mounts properly mount the engine as shown in the images below.
Standard Motor Mounting with proper sized frame.
 
Notice how the motor mounts fit flush against this type of frame. There is no need to modify these mounts in this situation. Again, be sure to mount the motor as low on the frame as possible while insuring the motor mounts fit flush.
Install and Align the Rear Drive Sprocket
Mounting the rear wheel sprocket is a critical part of the kit installation. It must be installed properly so that it will not move. It must then be tightened up uniformly insuring that it is straight. Tightening it unevenly or improperly will cause the sprocket to warp and therefore causing the chain to not track properly. Below is an image of the parts involved in mounting the rear wheel sprocket.
|| Pg1 || Pg2 || Pg3 || Pg4 || Pg5 || Pg6 || Pg7 ||
|| Pg8 || Pg9 || Pg10 || Pg11 || Pg12 || Pg13 ||
|
